Fuzhou Realcan Power System Co.,Ltd

Daily gasoline body disassembly will affect the life of the machine, we remind the majority of users in the disassembly time to pay attention to the following matters: small gasoline engine parts for the aluminum alloy, installed fasteners should not spin too tight, to preventthreads, is damaged. The demolition of the piston, remove the piston pin retaining ring, then the piston is placed around the oil heated to 160 ° C, the piston pin can be gently introduced. Piston installed some directionality, top arrow points to the exhaust port, and heat is strictly prohibited demolition ...

Small generators, the following 30KW generator, diesel generator set small generator body is lightweight, simple operation, low noise, for you to create a comfortable supply. The daily gasoline body disassembly will affect the life of the machine, it is best to be familiar with the basic structure of gasoline generators, we remind the majority of users in the disassembly time to note the following:

A. Small gasoline engine parts for aluminum, installed fasteners should not spin too tight, to prevent the threads, damaged.

Two. The demolition of the piston, remove the piston pin retaining ring, then the piston is placed around the oil heated to 160 ° C, the piston pin can be gently introduced. Piston installed a certain directionality, top arrow points to the exhaust port.

3. Demolition of piston rings, can not make the opening the opening is too large, in order to avoid deformation or break.

4. When installing the cylinder body, piston ring incision should be aligned with the locating pin of the piston ring slot, then the piston pushed into the cylinder, the cylinder intake manifold side crankcase high-voltage leads to the gap in the same direction.

5 Woodruff key of the magneto flywheel and cooling fan must be demolished, Puller magneto flywheel fitted, you must check with the quality, check in the keyway.

6. Piston, the half crankcase load before and after the moving parts of the connecting rod, diesel generator crankshaft, before and after the half crankcase shall be placed in the oil heated to 170 ° C and for 3min, immediately after removing the pressure into the moving parts on the right ball bearing. Half crankcase after the first install, installed after the first half of the crankcase.

7. Crankcase generally does not permit the demolition, such as must be removed to install front and rear crankcase joints must be coated with insulating varnish to remain sealed.

8. Prohibited the demolition of the heat.